WiFi signal has a very short wavelength (about 12 cm), as a result of which is well absorbed by all visible obstacles such as walls, doors. Reinforced concrete walls are the most difficult. As a result, WiFi cannot overcome a long distance. Also, the signal can shoot down various interference from household devices. Therefore, to place the right router in the house is extremely important. Here you have 5 recommendations, when implementing which WiFi will be perfectly catching in the entire apartment.
1. Place WiFi Router in the center of the dwelling
Try to place WiFi Router in the center of the apartment. If there is no such possibility, then you will choose the place as close as possible to the center.
Try to locate the router on open visibility, because any wall can significantly absorb the signal.
2. Do not put a router in closed rooms.
Do not install the router in closed rooms, storage rooms or dressing rooms, as even the usual wooden door and the walls around can reduce the level of reception. Poland the rother in the open space.
3. Do not place a WiFi router on the floor
The WiFi signal strive is always to the bottom, so placing the router on the floor you reduce the ability to propagate the signal in the plane of receiving your devices. Place the router either in the middle, between the floor and the ceiling, or a little higher.
4. Do not install WiFi Router next to the other electronics
Televisions, computers and other electronics create interference for WiFi signal, so try not to place the router near them.
5. For multiant routers, change the direction of the antennas
If you have a multi-antenna model of the router, then place one antenna perpendicular to the other. This will give the ability to radiate a signal in another plane. After all, the antennas in laptops and phones are not always in the same plane with the router and rather the opposite.
After all, the signal is well accepted when the antennas of the two device are parallel.
Other causes of bad WiFi signal
If all the recommendations are fulfilled, and the signal is still not stable, then it is possible to interfere with other residents of an apartment building. It is possible your router is configured to one of the channels that other routers are used for distribution. How to scan accessible channels and perform an elementary reunification of the router Read here -
