Good afternoon, my reader. It seems to many that cutting a tree - the task is not difficult, even a teenager's task. Breaking - do not build. Perhaps this is true, but only about young low trees with subtle trunks. But not everyone will be able to sow an adult mighty tree. Even if it is armed with the most modern tool, without the necessary theoretical preparation for it it is better not to take. The work itself on the roll tree passes in several stages. To successfully cope with it, it is necessary to observe a certain sequence of their implementation.
First of all, one should objectively assess its own forces. And the point here is not even in the strength of physical, as in the ability. After all, the tree cut down a little or cut, you still need to clean it so as not to damage the buildings on Earth, cars, power lines, and not to suffer. If we are talking about large trees with thick trunks and an empty crown of the wrong shape, then do it, without possessing the appropriate skills, it will not be easy. Sometimes it is better to use the services of specialists.
If it is possible, it is better to carry out it in the fall or early spring, before the start of the landing work. The freerly adjacent territory, the easier it will determine which way to put the trunk. Yes, and if something goes wrong, you can quickly run off at a safe distance.
It is impossible to start a cutting tree into windy weather, since the trajectory of its fall in this case will be unpredictable. It should be borne in mind that the wind can not be felt at the bottom. Therefore, before starting work, it will not be superfluous to take a look at the crown - if her crown is pregnant, it is desirable to carry the cutting of the tree to another time.
The radius of the work area is determined by the value of the height of the tree, to which several meters are added, because during falling the barrel bounces from the stump for 1-2 m. The whole area near must be released from inventory and garden furniture, high grass is beveling, and if the earth is snowing, It is desirable to clear it. Increased attention should be paid to the work zone to be outsiders, especially children.
This is primarily an ax and saw. When using chainsaws, it is desirable not to neglect protective glasses. It is also necessary to take care of your own equipment that can reduce the risk of traumatic safety: the clothes should be closed, put on gloves, a thick cap or hard hat.
With their help, it will be easier to beat the tree, setting it the necessary trajectory of the fall.
It is cut down to the depth of a third of the thickness of the barrel from the other side of the tree, which it is planned to withdraw. It has a wedge-shaped form: the bottom cut is parallel to the ground, the upper - at an angle of 45 degrees to it.
It is done by a saw a little higher than the bottom cut of the hand, to the depth of half the thickness of the trunk, but not reaching it. Its fibers will hold the tree until the effort is applied to it for directions in a certain side of the fall.
By making feeders and girlfriends on the trunk of the tree, proceed to its bumping. The assistants simultaneously pull the ropes and pull them the trunk toward the outlined drop zone. If he does not give in, you can push it with your hands or take advantage of the lever.
The fallen tree is cut into parts, convenient for transportation when exporting from the site, or on a scrabble, which can then be chopped on firewood. The remaining garbage in the form of branches, pieces of the cortex, the leaves are collected by robbles and remove. It remains only to solve the fate of Stump - to emerge it or use it as original garden furniture (chair or table).