When repaired in the bathroom, bathroom, as well as when designing a kitchen apron, a facing can be made not tiled, but by conventional plaster plaster, simply reorganized and painted by the protective composition. This is at times cheaper, but look even better than most tiles collections. Consider this technology in more detail.
Materials:
- plaster plaster;
- primer deep penetration;
- color;
- Optically transparent epoxy resin.
Tile simulation process
Walls before decorative trim are required to be launched. It is necessary to remove even planes and straight angles. After drying the walls are ground.
Then there is a gypsum plaster to the consistency of thick sour cream.
It is applied with a wide spatula on one wall on top of a layer of 3-5 mm. At one time it is plastered about 1-2 m walls.
While the stucco is fresh, you need to create a texture on it applying and pulling the metal smooth iron or cell. The drawing should be chaotic, so the direction of the Kelma can be changed, like the force of the clutch.
After applying the invoice, you need to launch the next site, and also to decorate it. One wall should be done to do in one approach, so no visible transition will turn out.
When the plaster stops sticking, its drawing needs to be smoked with a wet spatula. To try to bring everything to the ideal at a time not worth it. You need to quickly walk all over the wall, and then make it a wet spatula repeatedly as required. There is a task to simply remove the protrusions of the plaster, but save the depressions.
Next, you need to cut the imitation of the seams. For this, in terms of the level, the rule is applied and the plaster is cut off. This is done by a homemade scraper. It can be cut out of the pruning profile.
If the speed of operation is low and the plaster grabbed, it is better to cut the cutter, sharpened from the file.
When the plaster is driving, it must be painted in 2 layers of deep penetration of the mixed in the desired color. The interval between the layers is at least 2 hours. The primer is applied with a roller.
The seams need to paint the small tassel soil, coated into a darker color. So the tiles will be highlighted better.
When the walls are dried after the primer, they need to be made moisture-resistant, applying an optically transparent epoxy resin. This is done by a small velor roller. It is applied with a thin layer so that there are no ilk. Its consumption for 15 sq. M of the walls turned out 800 ml, so it is necessary to buy it approximately with such a calculation.
As a result, we get beautiful moisture-resistant walls with a light gloss and perfect seams.
Watch the video
See how you can make a simple imitation of brickwork -