Cutting belt spring against insect pests

Good afternoon, my reader. In the spring wake up from winter hibernation not only plants, but also their pests. And then the task of the gardener is to protect your garden from insects. One of the best ways is the use of leaks. We will understand how they are used.

Casting belt in spring against pest insects Maria Verbilkova

The work of the belt is based on the fact that the strip of coarse tissue, paper, plastic or other materials creates a barrier through which the insect will be difficult in the soil or in the foliage foliage. This strip whose width is from 15 to 25 cm, is attached to the trunk at a height of about 25-30 cm above the soil. As a last resort, instead of finished belts, a plastic bottle can be used, which was cut along and put on the main barrel or a stramb.

With all his primitiveness, the belt stops:

• apple-tree frozing;
• apple and pear cateries;
• buccarca;
• white throat;
• Black garden ants carrying tool.

Its use is based on the fact that the surface is either slippery (and insects cannot cross it), or, on the contrary, extremely rough and moving around it.

It is done in the form of an ordinary or double "skirt", where one edge adjacent to the trunk, and the second leaves for some distance. The double funnel turns out if you take a belt in the middle of the tight braid from the jute twine, bending the edge up and down. Insecting insects regularly shake and destroy. A double cone is needed that in the upper "skirt" stuffed in the fall of pests, going to the winter in the soil.

In this case, the conventional belt is still applied to the holter, to which the pests stick. In addition to glue, an insecticide may be added, which kills insects.

The sticky belt is regularly brushed from the glued pests. If there are too many of them, the material band is simply changed, burning used.

Casting belt in spring against pest insects Maria Verbilkova

So that insects (ladybugs, bees, etc.) do not come across the velcro (ladybugs, bees, etc.), experts recommend painting it into green: these insects do not attract her insects - but leafy will be eager for her.

Ready Love Belt Install the manufacturer's instructions. Homemade is fixed like this:

1. Tight cloth wrapped with two coils along the strain.
2. From above on it fasten the narrow strip of the polyethylene film - so that 5-7 cm remained to the edges of the fabric from above and below.
3. The belt is tied up with garden twine, lubs lubs.
4. Apply the adhesive basis in the form of a special sprayed glue. This is an optional stage, but it is needed for the manufacture of a sticky belt.

The finished belt is kept on the trunk until the end of the summer, once a month spraying a new layer of Claysther. After that, the belt is removed and burned.

The belt with a layer of sticky glue applied on them is fixed on trunks in the period from the moment of heating the Earth and to swelling the kidneys. Later it is already pointless to establish them: if the pests were, they are already on the tree.

The second time of the belt is set after harvesting and before cooling - to assemble the ticks, whiteflinks, tool and other pests heading for wintering.