The RS-550 electric motor is used in a different battery tool, even very well-known brands like Makita. This is a visual proof that self-made on its base will have high-level performance. From this motor, you can collect a very simple, but powerful and reliable bormer.
Materials:
- Electromotor RS-550 - http://alii.pub/5nigtf
- Pipe sewer 40 mm;
- Drilling cartridge on a microdril shaft - http://alii.pub/5nigro
- sheet plastic;
- Roll Controller - http://alii.pub/5nigqp
- power supply connector;
- button;
- 12V power supply - http://alii.pub/5nigpc
- plywood 100 mm;
- tin
The process of making Bormaryshka
From trimming plastic pipe 40 mm you need to make the body of the borders. It perfectly places the engine, as its diameter is 35 mm.
The pipe is taken with a margin to also place the revolver regulator in it, the connector for the power supply and switch. It immediately cuts over the vent hole.
At the end of the pipe you need to make cuts, warm them up and bend to fasten the engine.
A drilling cartridge is installed on the motor shaft.
From the reverse side to the pipe you need to fasten 3 lumps, to which the lid will be installed. So that they do not hang out, they can still go into account.
A plug on the body of the borders is cut out of the sheet plastic. It needs to be embedded in the revolver regulator, the connector for connecting the power supply, and if you wish, the power button. Equipment is installed and soldered. The lid itself is screwed to the wooden mortgage.
As a result, we get a lightweight bormer with revolutions.
Also for it can be made milling database. It is glued at a right angle of 2 plywood, fortified with sideways.
In the sole of the base is done propyl. There is a burgher over him. To do this, on the basis of 2 rails, to which the engine is pressed by a clamp cut out from tin.
Weakening the clamp, you can adjust the departure of the installed cutter. With a full-sized milling mill, such a tool is incomparable, but it is able to do anything small snap-in tool.
Watch the video
How to make a mini drill with your own hands in the housing of the syringe - https://sdelaysam-svoimirukami.ru/3797-mini-drel-svoimi-rukami.html