The inner part of the split system is dismantled in case of failure, clogging or during repairs and the question arises as well to remove, so as not to damage the air conditioner and is it possible to do without displacement from the wall.
Before calling the masters, appreciate the scope of work, and it is possible to remove the air conditioner before repairing from the inner wall with your own hands.
Most often, the climatic installation is removed when changing the wall finishing material, for which the device is disassembled.
Climathors are fastened with three types of clips:
• the hook for the vertical plane from above, allows you to remove the device from the wall, and hang the air conditioner back, clicking on the latches at the top
• Fastening the plate from below is equipped with additional holes and to dismantle in the room the unit, the clip is delayed down.
• Clips are placed inside the block under the decorative lid and with disassembly remove the outer panel, unscrew the fasteners and uncover it from the sides.
Incorrect actions lead to the device breakdown, and since the rules to remove the inner block can a master or person with experience, then the air conditioner can be dismantled from the wall to be difficult.
Precautions
Before removing the lid or the entire internal block, read the design of the air conditioner. The device consists of two parts, with combined highways, according to which freon moves. The unit hangs on the wall, on the tubes of which the refrigerant moves along two tubes with different diameters - in a liquid and gaseous state.
Possible problems:
• Full or partial freon leakage occurs if it is incorrect to turn off the main pipelines.
• At that moment, as it was decided to remove the climate system for any reason from the wall, follow the air, which the air conditioner does not get into the heat exchanger, which starts work on your own, make sure of your abilities.
• It is recommended to leave tags on terminals to facilitate the re-connection of the system.
• Make sure whether it is possible to cut a drainage tube before removing the air conditioner. If it is short - it is impossible to cut, call the wizard who professionally dismantle the device from the wall.
Features of the process
At the first stage, copper tubes are disconnected, and since they cannot be reused, before removing the air conditioner, purchase new ones. Pipes are cut from the wall of 20 cm from the fitting and seal seals. Two people will need for work - one helps outside, the other in the room. After examining the instructions in detail, disassembling the split system is available, but if you have never encountered similar problems for the first time better to use the service services.